SquareWear LED Badge Kit

SquareWear LED Badge Kit
SquareWear LED Badge Kit SquareWear LED Badge Kit SquareWear LED Badge Kit SquareWear LED Badge Kit SquareWear LED Badge Kit SquareWear LED Badge Kit
Product Code: sqw_led_badge
Availability: In Stock
Price: $10.00

Available Options


* 3mm LED Color:



Qty:     - OR -   Add to Wish List
Add to Compare

This is a DIY kit (requires soldering) to make your own LED badge and use it with SquareWear! The board measures 2″x2″ (5cmx5cm) and is fits 3mm LEDs. The kit comes with:

  • One LED badge PCB
  • 50 of 3mm LEDs at yoru choice of color (red or green)
  • Two alligator cables

To use it, design a pixel pattern you like, such as a smiley, a heart, or a letter etc. Then insert LEDs to the corresponding pins. The longer (positive) lead of the LED should go into the pin marked ‘+‘. Half-grid points are allowed, as long as the longer lead goes into a ‘+’ pin. All LEDs are connected in parallel, so they will all light up together. You can fit a SquareWear behind this board (using double sided tape and appropriate insulation) to make a standalone LED badge.

The board has sewable pin holes on the four corners. To control it with SquareWear, connect the + sewable pin to SquareWear’s Vdd, and -sewable pin to one of the power sink pins.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Powered By OpenCart
Rayshobby Shop © 2017